|
Specifications
- MX-BPM
|
| Electrical
|
| Beam
Intensity Range |
>75dB |
| Input
Signals |
+5dBm
to -70dBm in to 50 ohms |
| Operating
Frequency |
60
- 800MHz |
| Noise
(rms) |
<2mV
[0 to 1kHz] in ±10V @ -5dBm
<5mV [0 to 1kHz] in ±10V @ -35dBm
<50mV [0 to 1kHz] in ±10V @ -60dBm |
| Linearity
Error |
On
center: <5mV [+5dBm to -35dBm]
2mm off center: <20mV [+5dBm to -35dBm] |
| Sensitivity |
Programmable,
but 1V/mm is recommended |
| Gain,
X & Y |
Factory
set as required by vacuum chamber used |
| Sampling
Rate |
2,000
per second with internal clock
up to 10,000 per second when using an external
clock |
| Local
Oscillator |
Factory
set |
| Intermediate
Frequency |
10.7MHz
or 21.4MHz, depending on ƒrev |
| Outputs |
X:
±10V, A-B-C+D or D-B
Y: ±10V, A+B-C-D or A-C
Sum: A+B+C+D or 3V
A, B, C and D: >0 to <+10V |
| Single
Button Output |
Output
on "X": >0 to <+10V |
| Button
Address |
Two
address lines, TTL |
| Single
Button Sampling |
Enable
and Reset, TTL |
| Fast
Gate Mode |
Enables
TTL command |
| Fast
Gate |
NIM
(50 ohms, negative pulse, -16mA) |
| PLL
Lock Indicator |
Front
Panel LED |
| Power
Supply |
+15V
@ <200mA, -15V @ <40mA |
| Connectors
|
| Rear
Connector |
DIN41612-M,
24 + 8 co-axial (4 used, size 1.0/2.3) |
| Front
Panel Connectors |
DB9,
female for test signals
SMA, for optional IF output |
| Rack
Mounting Enclosure |
| Type |
19"
Rack Mount Chassis, 3U, RF Shielded |
| Capacity |
16
BPM Euromodules |
| Power
Supply |
±15V
output, 100 to 240VAC, 50/60Hz input |
| Includes |
One
BPM test station
Rear panel with SMA input for button signal
inputs
DB9 male connector for external command input
DB15 female oupput connector per installed
station |
