| |
The 860R-5000 is no longer in production see Discontinued Products.
|
For
applications where the full scale current range is often
changing, consider using the 860S current range
selector. Installed between the 860R and the
Transducer head, this unit provides a simple method or
current range selection in a laboratory or metrology environment.
If only one or two ranges are of interest, use one of
the range programming plugs. These plugs are available
in either unwired (for user wiring) or prewired for the
following ranges: 40/125A, 80/250A, 120/375A, 160/500A,
200,625A, 240/750A, 280/875A, 360/1125A, 400/1250A, 440/1375A,
480/1500A, 520/1625A, 560/1750A, 600/1875A, and 2000A.
For the full scale range of 320/1000A a range programming
plug is not required.
Range programming is not available for the 860R-5000 or
862 systems
|
 16900451 Primary Current Cable for DC or AC measurements to 500A rms. These cables are constructed
using three flexible cables terminated in a lug.
These cables allow 'splitting' of the return current around
the transducer, reducing the radiating loop area and improving frequency response.
Additional Data:
Drawing: 16900451
Revision B - PDF - 78kB
|
 199080011 Cable Kit is for DC or AC measurements to 1,500A rms. The cables are constructed
using four flexible cables with lugs. Plates on each side of the head locate the cables approximately, symmetrically around the head to reduce the radiating loop area and and improve frequency response.
|
 Busbars are for DC measurements to 2,000A. Busbar is a solid bar with locating o-rings. Current cables are connected to each end.
866-BB - Busbar for 600A transducer head
860-BB-2000 - Busbar for 2000A transducer head
The 862-BB-10 is for use with the 862R-1000 for
currents up to 10,000 amps.
|
The
88372B transducer cable is used between the 860R
(or 860S) and the transducer head. Standard
lengths are 2.5, 5.0, 10, 20, and 30 meters. Note
that the bandwidth of the 860 system may be reduced with
the longer cables.
The 862-CC transducer cable is for used between
the 862R and it's transducer head. Standard
lengths are 10, 15 and 20 meters.
|
For
the signal output of the 860R or 862R, use the 860-BB
signal output cable. This cable is user
modifiable for use with either low or high impedance loads. The
standard delivery is wired for high impedance, and it
is 2.5 meters long
This page was last updated on
6 December, 2007
|
|
|
|
