 The
866-VOM Voltage Output Module
provides a ±10 volt output for the 866, and is
available with full scale ranges of: ±75A, ±150A,
±300A, and ±600A.
This item is available for the 866 models only
and factory Installation is recommend.
|
 16900451 Primary Current Cable for DC or AC measurements to 500A rms. These cables are constructed
using three flexible cables terminated in a lug.
These cables allow 'splitting' of the return current around
the transducer, reducing the radiating loop area and improving frequency response.
Additional Data:
Drawing: 16900451
Revision B - PDF - 78kB
|
 Busbars are for DC measurements to 600A. Busbar is a solid bar with locating o-rings. Current cables are connected to each end.
866-BB - Busbar for 600A transducer head
|
 The
866-MB Mounting Bracket allows a single 866-600
to be mounted perpendicularly to a chasis or frame.
One is required for each 866-600 mounted in to the 11902340
Current Transducer Cabinet.
|
 The
11902340 Current Transducer Cabinet provides mounting
for up to three 866-600 Current Transducers with 16900451
Primary Current Cables installed.
For currents up to 30 amps, up to six 866-600 current
trandsucers with custom primary current cables may be
mounted in the 11902340.
Additional Data:
Drawing: 11902340
Revision A - PDF - 61kB
|
 Use
the SP10381 Signal and Power Cable to make your
connections to the 866-600 & 867-400. It is 2 meters
long, with a female DB9 connector on one end and flying
leads on the other end for user connection.
|
 If
you do not want flying leads on your connection cable,
then use the SP10005
Signal and Power Cable to make your connections to the
866-600 & 867-400. It is 5 meters long, with a female
DB9 connector on one end and a
female DB9 on the other end.
|
The
866-FIB Fiber Optic Trigger Input. Use this when
it is desirable to synchronize several 866 Transducers
together. Once installed, the zero flux detector is slaved
to this input.
Please note that if the 866-FIB is installed but not used,
the 866 Transducer will not function.
This item is available for the 866 models only
and factory Installation is recommend.
This page was last updated on 31 October, 2007
|
