The
866R-VOM Voltage Output Module
provides a ±1 volt peak output for the 866R, and is
available with full scale current output ranges defined in the
866R-VOM Selection Chart.
This item is available for the 866R models only
and factory Installation is recommend.
|
 16900451 Primary Current Cable for DC or AC measurements to 500A rms. These cables are constructed
using three flexible cables terminated in a lug.
These cables allow 'splitting' of the return current around
the transducer, reducing the radiating loop area and improving frequency response.
Additional Data:
Drawing: 16900451
Revision B - PDF - 78kB
|
 Busbars are for DC measurements to 2,000A. Busbar is a solid bar with locating o-rings. Current cables are connected to each end.
866-BB - Busbar for 600A transducer head
|
 If
you do not want flying leads on your connection cable,
then use the SP10005
Signal and Power Cable to make your connections to the
867-400. It is 5 meters long, with a female DB9 connector
on one end and a
female DB9 on the other end.
|
 The
866-MB Mounting Bracket allows a single 866 to
be mounted perpendicularly to a chasis or frame.
|
 The
11902340 Current Transducer Cabinet provides mounting
for up to three 866-600 Current Transducers with 16900451
Primary Current Cables installed.
For currents up to 30 amps, up to six 866-600 current
trandsucers with custom primary current cables may be
mounted in the 11902340.
|
The
866-FIB Fiber Optic Trigger Input. Use this when
it is desirable to synchronize several 866 Transducers
together. Once installed, the zero flux detector is slaved
to this input.
Please note that if the 866-FIB is installed but not used,
the 866 Transducer will not function.
This item is available for the 866 models only
and factory Installation is recommend.
This page was last updated on 4 March, 2008
|
